Tapered Roller Bearings
This conical geometry creates a linear contact patch which permits greater loads to be carried than with spherical (ball) bearings, which have point contact. The geometry means that the tangential speeds of the surfaces of each of the rollers are the same as their raceways along the whole length of the contact patch and no differential scrubbing occurs.
The U type tapered roller bearings are an exception within the conventional tapered roller bearings since this is a compact unit type that includes the grease and is pre-regulated without having to install an opposite bearing. Furthermore, they have a flange on the outer ring that is fastened axially in the application once the bearing is mounted.Two rows of rollers give these bearings load capacities over five times higher than comparably sized tapered-roller bearings. One-Way Locking Needle-Roller Bearing Clutches. The needles in these bearings roll freely in one direction, but lock to transmit torque when the rotation of the shaft is reversed.
- 60 mm x 130 mm x 31 mm NKE 30312 tapered roller bearings
- 0 Inch | 0Millimeter
- Set Screw
- 95 mm x 145 mm x 39 mm NKE 33019 tapered roller bearings
- Teflon Labyrinth
- Yes
- 340 mm x 460 mm x 76 mm NKE 32968 tapered roller bearings
- 0883450315784
- Mounted Units &
- 60 mm x 130 mm x 46 mm NKE 32312 tapered roller bearings
- 1 (Single)
- Steel
- 65 mm x 120 mm x 23 mm NKE 30213 tapered roller bearings
- Ball Bearing
- 6.299 Inch | 160 Mil
- 105 mm x 160 mm x 35 mm NKE 32021-X tapered roller bearings
- 43.00 mm
- TIMKEN
- 95 mm x 200 mm x 45 mm NKE 31319-DF tapered roller bearings
- 7.874 Inch | 200 Mil
- Yes
- 60 mm x 100 mm x 30 mm NKE 33112 tapered roller bearings
- Y32008X
- 14.500 mm
- 280 mm x 380 mm x 63,5 mm NKE 32956 tapered roller bearings
- SCHAEFFLER GROUP
- N/A
- 65 mm x 140 mm x 48 mm SNR 32313A tapered roller bearings
- ABB MOTORS AND MECHA
- 0.0